An Analysis of the Abrasi̇ve Water Jet Machining of Polyethylene Using L9 Orthogonal Array
Yazarlar (1)
Prof. Dr. Fuat KARTAL Kastamonu Üniversitesi, Türkiye
| Bildiri Türü |
Tebliğ/Bildiri
|
Bildiri Dili | İngilizce |
| Bildiri Alt Türü | Tam Metin Olarak Yayınlanan Tebliğ (Uluslararası Kongre/Sempozyum) | ||
| Bildiri Niteliği | Alanında Hakemli Uluslararası Kongre/Sempozyum | ||
| Kongre Adı | 2017 WJTA-IMCA Conference Expo (New Orleans, Louisiana) | ||
| Kongre Tarihi | 25-10-2017 / 27-10-2017 | ||
| Basıldığı Ülke | Basıldığı Şehir | ||
| UAK Araştırma Alanları |
Üretim Teknolojileri
|
||
| Özet |
| In this study, Taguchi method was applied to find optimal process parameters for cutting 100 mm thick (HDPE) polyethylene sheet material with AWJ. This experimental study examines the effect of the process parameters on the material removal rate and average surface roughness values of polyethylene workpieces. For the optimizing the cutting process parameters with AWJ is to optimize the cutting efficiency and the standoff distance, the abrasive flow rate and traverse speed with the Taguchi method. Also used the ANOVA and signal-to-noise ratio (SN Ratio) to determine the optimal parameters. The L9 orthogonal array was used for parameters and response results were assigned. For each combination, a single experiment was performed and optimal results were obtained for the AWJ cutting with SN ratio. It has been verified that the specified optimal AWJ cutting process parameters meet the actual needs for processing of polyethylene in practice. |
| Anahtar Kelimeler |
