Preparation structural and micromechanical properties of Al Mg co doped ZnO nanoparticles by sol gel process

AŞIKUZUN TOKEŞER, Elif; ÖZTÜRK, Özgür; Arda, L.; Akcan, D.; Senol, S. D.; Terzioglu, C.

doi:10.1007/s10854-015-3475-4

Preparation structural and micromechanical properties of Al Mg co doped ZnO nanoparticles by sol gel process

Yazarlar (6)

Doç. Dr. Elif AŞIKUZUN TOKEŞER Kastamonu Üniversitesi, Türkiye

Prof. Dr. Özgür ÖZTÜRK Kastamonu Üniversitesi, Türkiye

L. Arda
Bahçeşehir Üniversitesi, Türkiye

D. Akcan
Bahçeşehir Üniversitesi, Türkiye

S. D. Senol
Bolu Abant İzzet Baysal Üniversitesi, Türkiye

C. Terzioglu
Bolu Abant İzzet Baysal Üniversitesi, Türkiye

Makale Türü	Özgün Makale (SSCI, AHCI, SCI, SCI-Exp dergilerinde yayınlanan tam makale)
Dergi Adı	Journal of Materials Science Materials in Electronics
Dergi ISSN	0957-4522 Wos Dergi Scopus Dergi
Dergi Tarandığı Indeksler	SCI-Expanded
Makale Dili	İngilizce	Basım Tarihi	10-2015
Cilt / Sayı / Sayfa	26 / 10 / 8147–8159	DOI	10.1007/s10854-015-3475-4
Makale Linki	http://link.springer.com/10.1007/s10854-015-3475-4
UAK Araştırma Alanları	Yarı İletkenler

Özet

Zn0.90Mg0.10−xAlxO (x = 0.0, 0.1, 0.2, 0.3, 0.4, 0.5 and 0.10) nanoparticles were prepared by using sol–gel technique. The effects of Al and Mg doping on the structural and mechanical properties were investigated by using X-Ray diffraction (XRD), scanning electron microscopy (SEM) and digital micro-hardness tester, respectively. The grain size, a and c lattice parameters and morphology of nanoparticles were characterized by XRD and SEM measurements. The grain sizes of Al/Mg co-doped ZnO nanoparticles were also calculated by Scherrer–Warren equation. a and c lattice parameters are calculated from XRD peaks. According to the results it was observed that the grain sizes increased with increasing the Al doping. c lattice parameter partially decreased with Al doping. The experimental results of hardness measurements were analyzed using Meyer’s law, proportional specimen resistance model, elastic/plastic deformation model, and Hays–Kendall (HK) approach. It was observed that HK approach is the most successful model for the micro-hardness analysis of Al/Mg co-doped ZnO materials.

Anahtar Kelimeler

BM Sürdürülebilir Kalkınma Amaçları

Atıf Sayıları
Scopus	19

Preparation structural and micromechanical properties of Al Mg co doped ZnO nanoparticles by sol gel process

Dergi Adı	JOURNAL OF MATERIALS SCIENCE-MATERIALS IN ELECTRONICS
Yayıncı	Springer New York
Açık Erişim	Hayır
ISSN	0957-4522
E-ISSN	1573-482X
CiteScore	5,1
SJR	0,529
SNIP	0,712

Preparation structural and micromechanical properties of Al Mg co doped ZnO nanoparticles by sol gel process

Paylaş