Microstructure, wear and corrosion properties of NiB-TiC composite materials produced by powder metallurgy method.
Yazarlar (2)
Doç. Dr. Mehmet Akkaş Kastamonu Üniversitesi, Türkiye
Prof. Dr. Serkan ISLAK Kastamonu Üniversitesi, Türkiye
| Makale Türü |
Özgün Makale
(SSCI, AHCI, SCI, SCI-Exp dergilerinde yayınlanan tam makale)
|
||
| Dergi Adı | Science of Sintering (Q2) | ||
| Dergi ISSN | 0350-820X Wos Dergi Scopus Dergi | ||
| Dergi Tarandığı Indeksler | SCI-Expanded | ||
| Makale Dili | İngilizce | Basım Tarihi | 07-2019 |
| Cilt / Sayı / Sayfa | 51 / 3 / 327–338 | DOI | 10.2298/SOS1903327A |
| Makale Linki | http://www.doiserbia.nb.rs/Article.aspx?ID=0350-820X1903327A | ||
| Özet |
| In this study, NiB-TiC composite materials were produced using powder metallurgy. In the Ni-TiC-B powder mixture, TiC was fixed at a rate of 5 %, 5, 10 and 15 % boron was added and mechanical alloying was carried out. The prepared powder mixtures were cold pressed under pressure of 400 MPa and sintered in an argon atmosphere at 800°C for 2 hours. Microstructure, phase formation, hardness, wear and corrosion properties of the samples were investigated in detail. Scanning electron microscopy (SEM) was used for microstructure analysis and X-ray diffractogram (XRD) was used for phase formation detection. The hardness measurements of the samples were measured by a microhardness measuring device. Densities of the samples were determined by Archimedes' principle. The corrosion tests were performed potentiodynamic polarization curves of the composite materials in 3.5 % NaCl solution. Wear tests were carried out the composite materials under a load of 10 N. Results showed that by increasing the amount of B, the wear and corrosion resistance increased. |
| Anahtar Kelimeler |
| Corrosion | Mechanical alloying | NiB-TiC composites | Powder metallurgy | Sintering |
BM Sürdürülebilir Kalkınma Amaçları
| Atıf Sayıları | |
| Web of Science | 16 |
| Scopus | 18 |
| Google Scholar | 29 |