| Yazarlar |
Prof. Dr. Serkan ISLAK
Kastamonu Üniversitesi |
D. Kir
|
|
H. Celik
|
| Özet |
| Diamond and cubic boron nitride cBN cutting segments were produced using hot pressing technique for this study to be used in cutting natural stone. cBN grains were added to bronze powder, the chosen matrix, at a rate of 0%, 20%, 40%, 60%, 80%, and 100% (according to percentage by weight). Segments were produced under a pressure of 35 MPa, at a sintering temperature of 600°C, over a sintering time of 3 minutes. The cutting properties of the produced segments were determined by cutting Ankara andesite. A Scanning Electron Microscope SEM and an X-Ray Diffractometer XRD were used to analyse the microstructure, phase compound, and wear surfaces of each segment type. |
| Anahtar Kelimeler |
| CBN cutting tools | Hot-pressing technique | Wear |
| Makale Türü | Özgün Makale |
| Makale Alt Türü | ESCI dergilerinde yayımlanan tam makale |
| Dergi Adı | ARCHIVES OF METALLURGY AND MATERIALS |
| Dergi ISSN | 1733-3490 |
| Makale Dili | İngilizce |
| Basım Tarihi | 01-2013 |
| Cilt No | 58 |
| Sayı | 4 |
| Sayfalar | 1119 / 1123 |
| Doi Numarası | 10.2478/amm-2013-0135 |
| Atıf Sayıları | |
| WoS | 6 |
| SCOPUS | 7 |
